Mettler Toledo LP16 Operations Instructions download pdf (Page 10)

Switch on display (▼ Display changes automatically)

Display switched off (standby)

Briefly press controll bar; all display segments light up briefly

(automatic system and display check).

Software No. (e.g. 10.40.00, for information only).

Weighing mode

Lifting the control bar from below causes the display to blank out; the electronics are live

as long as the power cable is connected (Standby). The balance is thus always ready for

operation; no warm-up time required.

Note: If a power outage occurs during operation, the display will indicate OFF immediately the power is restored. You should then briefly press

the control bar (also consult «What if…».

Display subsequently indicates zero (weighing mode). The number of decimal places

depends on the readability of your balance model as well as the selected weight unit.

Operation

PCS

Stk

G B N TA

Switch off display

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

Mettler Toledo LP16 Operations Instructions Page 10