Mettler Toledo MX Operations Instructions download pdf (Page 13)

Section 2: Setting up the balance

2.5 Glass draft shield

The glass draft shield of your balance can be adapted to the environmental conditions and your weighing style, as well as to the

type of weighing and loading.

Draft shield on AX balances

The position of the coupling elements determines which parts (left-hand, right-hand,

and upper door) of the glass draft shield can be opened.

Try out various different combinations by moving the 4 coupling elements up and down.

We recommend arranging the glass draft shield in such a way that only those parts are

opened that are necessary for loading. Your balance then works faster, because the

disruptive air currents are weaker than when the glass draft shield is completely open.

The doors of the glass draft shield can be opened and closed either by means of the «2»

key, the “SmartSens” sensors, or by hand (this will be described in detail later in these

operating instructions).

Note: To open the doors by hand, the two lower coupling elements must always be

uncoupled (upper position)!

Draft shield on MX/UMX balances

The glass draft shield can be opened and closed either by means of the «2» key, the

“SmartSens” sensors, or by turning the door handle by hand. The door keys and

“SmartSens” sensors will be described in detail later in these operating instructions.

Note: The «2» key and the “SmartSens” sensor on the left-hand side of the terminal open

the draft shield for loading the balance from the right-hand side, whereas the «2» key

and the right-hand “SmartSens” sensor open the left-hand part of the draft shield.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 123 124

No comments

Mettler Toledo MX Operations Instructions Page 13