Mettler Toledo XPE Series Service Manual download pdf (Page 25)

5Maintenance

5.1Cleaning

Periodically clean the weighing pan, the drip tray, the housing, and the terminal of your balance using the

brush supplied with it. The maintenance interval depends on your standard operating procedure (SOP).

Please observe the following notes:

WARNING

Risk of electric shock

a) Disconnect the balance from the power supply prior to cleaning and maintenance.

b) Only use METTLER TOLEDO power cable, if these need to be replaced.

c) Ensure that no liquid comes into contact with the balance, terminal or AC adapter.

d) Do not open the balance, terminal or AC adapter.

These contain no user-serviceable parts.

CAUTION

Damage to balance

Under no circumstances use cleaning agents containing solvents or abrasive agents, as this

can damage the terminal overlay.

Cleaning

Your balance is made from high quality, resistant materials and can therefore be cleaned with a commercially

available, mild cleaning agent.

Note

All removable non-coated parts of the outer draft shield are dishwasher safe to 80 degrees.

1 To clean the weighing chamber thoroughly, move the draft shield glass panels (including intermediate

shelf) away from the balance and remove them from their fastenings.

2 Carefully lift the front of the weighing pan and lift it out of the guide.

3 Remove the drip tray from the balance.

4 Ensure that these parts are correctly positioned when refitted.

Note

Contact a METTLER TOLEDO representative to find about the service options available – regular maintenance

by an authorized service engineer will ensure consistent weighing accuracy over the long term and extend the

service life of the balance.

5.2Disposal

In conformance with the European Directive 2002/96/EC on Waste Electrical and Electronic

Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies

to countries outside the EU, per their specific requirements.

Please dispose of this product in accordance with local regulations at the collecting point

specified for electrical and electronic equipment. If you have any questions, please contact

the responsible authority or the distributor from which you purchased this device. Should this

device be passed on to other parties (for private or professional use), the content of this regu

lation must also be related.

Thank you for your contribution to environmental protection.

25Maintenance

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Mettler Toledo XPE Series Service Manual Page 25