Mettler Toledo AL-IC Operations Instructions download pdf (Page 43)

9 Application "Check Weighing"

The "Check weighing" application allows you to check the deviation of a sample weight within

a tolerance limit to a reference target weight.

Requirement: The function "CHECK" must be assigned to an «Fx» key (see advanced menu top

ic "ASSIGN:Fx", factory setting: F3).

CHECK

Activate function "CHECK" by pressing and holding the appropriate

assigned «Fx» key (factory setting: F3).

Step 1: Check weighing needs first a reference weight that should

correspond to the nominal weight, there are 2 possibilities:

Setting the reference in manual mode (enter nominal weight).

Setting the reference in weighing mode (weigh nominal weight).

Step 2: Check weighing needs the upper and lower limits:

Setting the upper and lower limits.

SET NOM .

Setting possibility:

Setting the reference by manual mode (enter nominal weight)

a) Press « » to activate manual mode.

b) Select the reference target weight by scrolling up («+» key) or down

(«–» key). Progressing speed by press and hold.

c) Press « » to confirm the nominal weight.

SET NOM .

Setting possibility:

Setting the reference by weighing mode (weigh nominal weight)

a) Press « » to tare the balance and to activate the weighing

mode. If using: place empty container on the weighing pan first or

tare again.

b) Load the nominal weight.

c) Press « » to confirm the nominal weight.

Switching between manual mode and weighing mode

Press « » to switch between manual mode and weighing mode.

Note: By switching from weighing mode to manual mode the weight val

ue will be transferred and can be changed manually.

MS-S / MS-L Models 43

Application "Check Weighing"

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 99 100

No comments

Mettler Toledo AL-IC Operations Instructions Page 43