49
PR/SR balances Applications – Plus/minus statistics
➜ Enter numeric value of positive tolerance (deviation to higher values) in the
displayed unit.
Possible values for "+T": 0 ... max. load or 0 ... 100 %. An entry outside the
admissable range leads to the message "Illegal value".
1. 3.
2.
2. Checking weight of samples and/or performing statistics
Depending on the setting of "Mode" and "WeightEntry" under the "+/–Stat"
application in the menu (section 6.1.5), plus/minus statistics proceeds in one of 4
ways:
Weight check on samples placed on pan singly with manual weight transfer)
(Factory setting: Mode = Single, WeightEntry = Manual)
➜ Confirm entry with H.
➜ If the settings of nominal weight and tolerances meet your requirements,
press␣ H again.
0.00 g
1 2 3 4 5 6 7 8 9 0 . <
+T=1.25 g
Cal / Test
0
Menu
Cal / Test
0
Menu
Nom -Tol +Tol Set100%
Nom -Tol +Tol Set100%
1 2 3 4 5 6 7 8 9 0 .
AutoCal BPTGNet
AutoCal BPTGNet
AutoCal BPTGNet
0.00 g-
-T=1.25 g
0.00 g-
Cal / Test
0
Menu
➜ Confirm entry with H.
➜ Press SmartBar under "+Tol", "+Tol=..." is displayed in the top line.
➜ Enter numeric value of negative tolerance (deviation to lower values) in the
displayed unit.
Possible values for "–T": 0 … max. load or 0 … 100 %. An entry outside the
admissible range leads to the message "Illegal value".
c) Changing tolerances
Depending on whether or not the parameter "+/–%" is activated in the menu under
this application, the tolerances are inputted in percent of the nominal weight or as
absolute weight values in weight unit 1.
➜ Press SmartBar under "–Tol", "–T=..." is displayed in the top line.
Comments to this Manuals