52
PR/SR balances
• If you wish, you can set the display to zero with the tare key Œ before placing the sample on the pan.
• If the parameter "+/–%" is activated in the menu under "+/–Stats" (section 6.1.5), all weighing results
appear in percent of the nominal weight. Switching to the weighing unit is possible.
• You can classify your samples according to the measured weight using the Input/Output Module LC-IO
attached to the balance (section 7.3). The outputs will be activated according to the following table:
Active output no. when weight value (wv) is
1 (for 0.3 sec) entered by pressing "M+" or automatically
2 stable
3 wv < Nominal – 2* (–Tol)
4 Nominal – 2* (–Tol) ≤ wv < Nominal – (–Tol)
5 Nominal – (–Tol) ≤ wv < Nominal
6 Nominal ≤ wv ≤ Nominal + (+Tol)
7 Nominal + (+Tol) < wv ≤ Nominal + 2* (+Tol)
8 wv > Nominal + 2* (+Tol)
AutoCal BPTGNet
0.00 g
Application
SetRef Results Clear
0.00 g-
<T- >T+ mean sdev srel
52.03 g-
Application
M+ n=0 x=0 Diff
0.00 g-
AutoCal BPTGNet
AutoCal BPTGNet
Cal / Test
0
Menu
Applications – Plus/minus statistics
3. Displaying the calculated results
The calculated results of the series can be called up in succession and one of them
always shown during weighing.
➜ Press SmartBar under "/".
➜ Press SmartBar under "Results".
The bottom line of the display shows the selection of the following results, whose
values appear in the top line marked by "✳".
"<T-" number of weighed samples below the lower tolerance
">T+" number of weighed samples above the upper tolerance
"mean" mean value (factory setting)
during weighing, "x=…" appears in the bottom line of the display
"sdev" standard deviation
during weighing, "s=…" appears in the bottom line of the display.
"srel" relative standard deviation (standard deviation in % of the calculated
mean value)
during weighing, "srel=…%" appears in the bottom line of the
display.
"min" smallest weighed value
"max" largest weighed value
"sum" sum
during weighing, "∑=…" appears in the bottom line of the display.
➜ Press SmartBar under the desired result.
The selected result is marked by ":" and its value displayed in the top line.
➜ Confirm selection with H.
From now on, the selected result is always shown in the bottom line during
weighing.
Comments to this Manuals